Vehicles
GTA 6 Driving Controls, Turn Signals and Handbrake

Quick answer
In the Default driving layout, use R2 or RT to accelerate, L2 or LT to brake and reverse, and Cross or A for the handbrake. Tap D-pad Left or Right to signal. Pause and check Settings → Control Scheme → Land / Water Vehicles if a preset changes the layout.
Use blinkers without opening a menu
With manual driving active, use a short Left or Right tap on the D-pad for that side’s signal. If you hold a directional button instead, you may trigger a menu or a secondary action. Start in a stationary car to see the difference. Check UI → Navigation for GPS Turn Indicators if you mean the on-screen directions.
Isolate what makes the car difficult to control
| Symptom | Quick comparison |
|---|---|
| The rear swings when you press Cross or A | That is the handbrake on Default. Try L2 or LT to slow down before the same in-game corner. |
| The car still slides with normal braking | Try the same low-speed turn without full throttle. Compare a second in-game car on the same surface to see whether the behavior follows the vehicle. |
| The car starts steering when the stick is centered | Test another game and try a small left-stick deadzone adjustment if necessary. |
| The PS5 accelerator stops at a resistance point | Check Controller → Adaptive Speed Limiter. GTA 6 uses that trigger point to help hold an appropriate road speed. It is separate from Auto Drive. |
Frequently asked questions
Can I use the old handbrake input?
Check your active scheme’s Land / Water Vehicles preview. The Default handbrake is Cross or A. A console-level remap may also affect buttons elsewhere.
Are the turn-signal taps the same as the GPS setting?
No. The D-pad taps operate the vehicle’s blinkers. GPS Turn Indicators change which navigation cues you see on the HUD.
What players are asking
Can I operate the turn signals manually?
Players comparing the launch driving controls